How to Use a DMT Vape Pen

The whole point of a DMT vape is that it’s simple to use. Nevertheless, there are a few steps to follow to get the most efficient hit from your vape.

Step 1: Shake the Pen

Always give the pen a good shake before you use it. The DMT will tend to separate from the e-liquid base, so if you skip this step, you will either get a hit of pure DMT or pure e-liquid.

Step 2: Take one Long Inhale, and Exhale Completely

This does two things; it calms you down before the hit, which is going to help reduce the chances of having a challenging or anxious experience. Secondly, it prepares you to take a longer, deeper breath during the next step, ultimately making the DMT more efficient.

Step 3: Take a Deep Inhale

Don’t rush it — inhale the vapor from the device slowly. It’s going to be pretty harsh, so taking longer, slower breaths will cut back on some of this harshness. Once you’ve taken a full inhale, release the pen and take one more inhale to bring all the vapor into the lungs.

Step 4: Hold Your Breath for a Few Seconds Before Exhaling

The DMT will immediately start absorbing through your lungs. Keeping the vapor in the lungs for a few seconds before exhaling allows you to get more efficiency from the DMT you’re using. The longer you hold your breath, the stronger the hit will be.

Step 5: Repeat as Necessary

Depending on the potency of your pen, the amount of vapor you inhaled, and the time you held the vapor in your lungs, you may need to take a few hits to reach breakthrough levels.

For a standard 400 mg, 0.5 mL vape cartridge, you may need between 5 and 15 hits to reach this effect level.

If using a mesh pen or stronger vape cartridge, you may only need 1–3 hits to reach breakthrough levels, so don’t rush it.

How Strong Are DMT Vape Pens?

Few psychedelics compete in terms of the depth of psychedelic experience than a DMT vape pen. They’re comparable in strength to ayahuasca but have substantially higher celerity.

Celerity is a term that describes the speed at which the psychedelic state of consciousness appears and disappears again.

Think “acceleration.” The faster a psychedelic accelerates, the sooner the race is over.

DMT vape pens are like a drag car — capable of reaching top speed almost instantly. But this comes at a cost — drag cars burn through their fuel quickly.

Substances with low celerity, like ayahuasca, take longer to get up to speed (reach peak effects) but also last much longer (6–10 hours). Ayahuasca is like a rally car — it’s much slower off the line but has the efficiency and fuel capacity to run for several hours.

A single hit of a vape pen can inject the user into deep psychedelic states in a matter of just a few seconds. The effects usually reach peak experience by the 10-minute mark and quickly fade out from there.

Just as fast as the experience begins, it goes away again. The total experience from a DMT vape pen rarely lasts longer than 30 minutes in total.

Leave a Reply

Your email address will not be published. Required fields are marked *

You cannot copy content of this page